You Are Here: Home » Blog » Electronics News Updates » Control Loop Challenges of Wireless Systems

Control Loop Challenges of Wireless Systems

Though embedded modules can be used be used with Wi-Fi, the aim of recent protocols is providing wireless networks with more focused support for control loops. For tight control loops, devices supporting the IEEE802.15.4 ZigBee standard can be used in supporting the recent protocols. Below is a Microchip’s MRF24WB Wi-Fi module.


For sharing a common medium of communication, sensors and controllers are required by a control system that is adopting wireless communication. The network’s quality is a trivial part of the functioning of the overall system when implementing a closed-loop control system using a common communication system.
Earlier short range wireless networks pose a problem since delay deadlines are not used in packet consideration and regardless of these requirements, the packets are treated the same. For a closed loop control system, this presents a major challenge since actuators influencing the system are controlled by the sensor’s data. Data delays lead to negative reinforcement, hence instead of a process being kept within close limits, it runs away.An open loop system, on the other hand, returns analyzed data with changes to a central controller, ordered in minutes or even seconds. In situations or processes that change slowly, the above is used where the process can be brought back easily, is not within its limit or terminated.

The above can be by-passed by having an application use the wireless medium associating every packet with a delay requirement. In a system where a high number of users exist, Wireless Sensor Network simulations done using the IEEE 802.15.4 standard showed a considerable outperformance of the original standards by these mechanisms.
Researchers are looking into using IP technology to be used in wireless networks to provide deterministic control loops. The use of machine-to-machine applications (M2M) has been increasing. In a typical M2M scenario, an anomaly is detected by the sensor then sends to a monitoring middleware an alert that gives information to a business operation software, produces a command for an actuator, and to an operator off the loop, it sends an alarm.

For more detail: Control Loop Challenges of Wireless Systems

Leave a Comment

You must be logged in to post a comment.

Read previous post:
3A Unipolar Stepper Motor Driver

This tiny Unipolar stepper motor driver has been designed around SLA7078MPR IC from Sanken, It is unipolar stepper Motor driver...

Scroll to top