You Are Here: Home » Blog » Electronics News Updates » L293D Motor Direction Control for Under $2.20

L293D Motor Direction Control for Under $2.20




Further to my instructable 12V NE555 PWM Controller for Under $3 I have designed and built a simple and cheap DC Motor Direction Controller that can either be used with the PWM Controller, for speed control or by itself with a 12V power supply.

I designed this DC Motor Direction Controller so that I could give direction control to DC motors that I am building into mini tools (drill, lathe, table saw, solder smoke extractor, etc.). While, I don’t need direction control for all of the tools that I’m building, it IS necessary for some. Plus, who doesn’t want to spin their DC motor backwards?L293D Motor Direction Control for Under $2.20

The overarching design principles that I’ve used here are:

  1. Works with my NE555 PWM Controller;
  2. Works without my NE555 PWM Controller;
  3. It’s cheap;
  4. It uses minimum parts; and
  5. It works

For the direction controller to work with the NE555 PWM Controller, it will take the PWM modified power from that device and modify the polarity of the signal and push it on to the DC Motor. As I mentioned with the NE555 PWM Controller, I’m only interested in a 12V motor.

To achieve this magic, I’m using an L293D Quadruple Half-H Driver, well … I’m using half of one. If you’re interested, the L293D can manage 36V, however, as discussed in my previous instructable, the NE555 PWM Controller (as designed) will handle 18V max. So there’s your upper limit.

The parts list and costing for this instructable is:

  • 1 x LM7805 Voltage Regulator ($0.40)
  • 2 x 100 nF electrolytic capacitor ($0.06)
  • 2 x 2 pin header ($0.26)
  • 1 x 1k ohm resistor ($0.01)
  • 1 x SPDT slide switch ($0.05)
  • 1 x L293D Quad Half-H Driver ($0.85)
  • 1 x 16 pin DIL ($0.35)
  • 1 x 50 x 33mm PCB ($0.14)

The prices quoted are for parts purchased from eBay that I’ve accumulated over some time. These prices change over time … so caveat emptor, dude.

Step 1: The Horse Before the CartSchematic L293D Motor Direction Control for Under $2.20

If you are using this with the NE555 PWM Controller, that device comes first. The reason for this is simply that if the LD293D direction controller were first, you’d be switching polarity and THEN feeding it to the NE555 PWM Controller. And that would mean that the polarity would be wrong and the NE555 PWM Controller wouldn’t work when the polarity was reversed.

For more detail: L293D Motor Direction Control for Under $2.20

Leave a Comment

You must be logged in to post a comment.

Read previous post:
Scrumtato Make Daily Stand-Ups Agile Again
Scrumtato: Make Daily Stand-Ups Agile Again

Story The following was originally published in my blog. At Delphi in Gothenburg, where I am currently employed, we create...

Close
Scroll to top