You Are Here: Home » Blog » Electronics News Updates » PSU Burner – a power supply tester

PSU Burner – a power supply tester


What does one do when designing a power supply? Well, build a power supply tester, of course. One of the simplest things to build is a constant current load. This will allow for testing of the endurance of the power supply, as most of the designs out there are using slow components.

PSU Burner – a power supply tester

However, I wanted to make a better one: one that I could hook up to my Analog Discovery and generate a test waveform to be able to connect and disconnect the load fast. This is a weekend project, so all parts are not the best for the purpose, just what I had around.

Warning: The analog discovery is grounded through your PC (unless using a laptop on battery only) so you have to make sure that both the supply being tested and the auxiliary 12V supply are isolated and not grounded. Or use an isolated aux supply and a USB optical isolator if the supply under test is grounded.

Update: Check the PSU Burner being tested with a real power supply in my PeakTeck 6225A review.

Take 1

The simplest of design, one OP-AMP driving 3 MOSFETs. All fine until I made a mistake: with the signal generator connected and turned ON, i connected a 24V 5A supply that was already on, while the signal generator was providing a square wave for 5A current. This caused one of the MOSFETs to blow up (shorting) due to an avalanche event. Finally the power supply went into hiccup mode.

Have you ever seen a fuse pulsating? With the output of the supply shorted and the fuse quite at the limit of the current, it is almost melting each time the power supply tries to restart

Take 2

There are some improvements, so let’s go through the schematic first. The way it works is simple: U1A will drive Q1 such that the voltage across R6 is equal to the reference at it’s positive input. This in effect creates a constant current being drawn from the test power supply.

Read more: PSU Burner – a power supply tester

Leave a Comment

You must be logged in to post a comment.

Read previous post:
BMP380 – Ultra-miniature pressure sensor
BMP380 – Ultra-miniature pressure sensor

The BMP380 is aimed at the growing markets of gaming, sports and health management, as well as indoor and outdoor...

Scroll to top