avr bascom

Stepper motor Driver Using AT2313 microcontroller

Description With this circuit you can drive a unipolar stepper motor. It operates in full step mode. You can get a stepper motor from an old 5.25 disk drive. The AVR attiny2313 micro controller controls the pulses for the stepper motor. The pulses are amplified by the ULN2003 driver. The driver accepts 5V inputs, the […]

Stepper motor Driver Using AT2313 microcontroller Read More »

Real Time Clock PCF8583 Using AVR microcontroller

Real Time Clock PCF8583 Using AVR microcontroller

Description The PCF8583 is a clock/calendar circuit based on a 2048-bit static CMOS RAM organized as 256 words by 8 bits. Addresses and data are transferred serially via the two-line bidirectional I2C-bus. The built-in word address register is incremented automatically after each written or read data byte. Address pin A0 is used for programming the

Real Time Clock PCF8583 Using AVR microcontroller Read More »

PC Thermometer Using ATTiny2313

Description With this project you can show the temperature on you PC. This thermometer plugs in on any free serial port. It gives temperature readings accurate to 0.5°C with no calibration.The project consists of the ATTiny2313 RS232 Project board and the DS1621 Thermometer board and software for the PC. It can display both indoor and

PC Thermometer Using ATTiny2313 Read More »

LCD Thermometer TCN75 Using ATTiny2313

Description This small thermometer board uses the Microchip TCN75 device. It is a cheaper clone of the LM75, it costs about 2,50 Euro. The TCN75 comes in a SO8 packaging. The TCN75 is a serially programmable temperature sensor. It has an output that is programmable as either a simple comparator for thermostat operation or as

LCD Thermometer TCN75 Using ATTiny2313 Read More »

Scroll to Top