USB Power supply Active Load Tester or short PAL Tester is unit designed for testing the quality of the power supplies.
Idea was to create low-cost, precise device for simultaneous measurement of Voltage and Current drawn from the device under test. This is one of my weekend projects that I have decided to release to the public. All source files can be found on projects GitHub page.
Device Features:
- Open Source and Open Hardware
- Modular design, easy to understand and change/adapt to your needs
- Uses widely available and off-the shelf components
- Components Bill of Material is below $10
- Integrated USB-to-Serial converter for easier interface with the device
- API for communicating with PC
- Recording Voltage vs Amps data and graphing the results
- Easy to use
Basic capabilities:
- PSU under test max voltage 55V
- Current Load of 5A (or more by changing Rs value)
- Current and Voltage measurement accuracy is below 5%
Component list and estimated price:
- 1x – PIC16F1829 [$1.6]
- 1x – MCP6002 Rail-to-Rail OpAmp [$0.69]
- 1x – MCP4726 12bit DAC [$0.96]
- 1x – IRF L3705 Logic Level N-MOSFET [$0.5]
- 1x – CH340T USB-to-Serial converter [$0.99]
- 10x – 1 ohm 1% 1/2W resistor
miscellaneous (resistors and capacitors)
How to build your own USB Power supply Active Load Tester:
If you are going to use photo etching or toner transfer method to make DIY board, there are bottom layer printouts in the Hardware folder that are ready for you to print and create a board via your favorite PCB manufacturing technique.
Once you have finished with developing, cleaning and drilling the board, in Hardware folder you have a file “Component-placement.png” which shows how and where to position components.
If you want to make changes or review the design, Schematic files (in .pdf) and Altium project files are available for download in Hardware folder. Open the design files in Altium or convert them to your favourite CAD and edit them.
For more detail: USB power supply active load tester
