You Are Here: Home » AVR ATmega Projects » Sensor - Transducer - Detector Projects » Cellular Data Logger

Cellular Data Logger




Story

I have been collecting data from Raleigh’s trails and parks for the last couple years.  My primary platform has been a custom Arduino board I developed for low-cost (hey, these things may get damaged or stolen) and long battery life.  I wanted a connected sensor to provide current data and, after looking at various technologies, I have settled on cellular as the most convenient.  Cellular Data Logger

This sensor uses an off-the shelf Adafruit FONA board for the cellular communications.  At $39 with an easy to use library and the issues of power consumption spikes solved, this is a great value.  I developed a carrier board to support my i2c connected sensors, support some field adjustments (with two potentiometers) and display status with three LEDS.  This board is designed to run off a LiPo single-cell battery and can accommodate optional Solar charging (see my other projects).

I have been operating this data logger with my Solar Power manager for some time now and wanted to share the results.  Below are a couple screen shots showing the Ubidots Dashboard for this data logger and a closer look at the battery charge level over a month’s time.  Notice that with a relatively small solar panel and battery, I have been able to report hourly each day without the battery charge level going below 87%.

The hardest part was in writing the software to manage all the issues that can arise when trying to send data over a 2G GPRS connection.  I ended up writing my own code to manage the excellent Adafruit library commands and documented it on the Ubidots site. With this code, I could re reliable connections and up to 10 days coverage from a 2000mAH LiPo battery.  The Solar power project keeps this system running with only 3 hours of sunlight a week.Schematic Cellular Data Logger

One of the issues I have looked into is the cellular data plan.  As this is a 2G modem, you need to understand that the networks that support this device are being replaced by 3 and 4G versions.  In my area, Raleigh NC, there are only two – T-Mobile and AT&T who has committed to keep them going until 2017.  I started with T-Mobile pre-paid SIMs which give unlimited 2G data for $2/day and don’t charge when you are not using them.  This is great when you are doing intermittent development and test but expensive after that.  I then moved to a machine to machine (m2m) provider Embedded Works. who offered a Vodafone card that uses the AT&T network (see hardware list below).  This gave me much better network performance and costs only about $42 for 6-months of services as long as you stay under a 5Gb/month cap.  Now, Sparkfun and Adafruit have m2m plans as well which I will certainly consider at renewal time.

For more detail: Cellular Data Logger

Leave a Comment

You must be logged in to post a comment.

Read previous post:
A dual sensor fan controller build
A dual sensor fan controller build

A while back, I added a fan controller to my Topward 6603A power supply. Later on, when I bought a...

Close
Scroll to top