You Are Here: Home » AVR ATmega Projects » Ponyprog Circuit for ATMEL’S AVR using microcontroller

Ponyprog Circuit for ATMEL’S AVR using microcontroller




The ATMEL AVR programmer works with the Windows program “Ponyprog” which works under 95, 98, XP, … and can be found at http://www.lancos.com/prog.html

Schematic




On board the AVRs that can be programmed are those in the schematic. For other members of AVR family or the rest programmable ICs that Ponyprog can program, there is the J1 connector (CON10) which allows expanding the programmer’s hardware. See Ponyprog’s site for other’s ICs Ponyprog circuits. The JUMP1 jumper is there to connect the crystal’s circuitry to the 8-
pin AVRs or to disconnect it.

For more detail: Ponyprog Circuit for ATMEL’S AVR  using microcontroller

Leave a Comment

You must be logged in to post a comment.

Read previous post:
EPROM adapter for ATMEL 89 Series Flash Microcontroller Programmer

Devices The EEprom programmer software supports the following devices. 28C16 28C256 28C17 29C256 28C64 Hardware Diode D1 and resistor R1...

Close
Scroll to top