Summary of Interfacing 8051 Microcontroller With 7 Segment Display
This project explains interfacing a 7-segment display with an 8051 microcontroller using Proteus simulation and Keil uVision (C51). It outlines required software, hardware components, circuit steps, source code location on GitHub, and a demonstration video showing hex codes for displaying digits.
Parts used in the Interfacing 8051 Microcontroller With 7 Segment Display Project:
- 8051 Development board
- Seven Segment Display (Common Anode used in simulation)
- USB to UART converter (9 pin D type male connector for RS232)
- Jumper wires
- Proteus simulation software (for simulation)
- Keil uVision (C51 compiler for coding)
- Flash Magic (for uploading code to Philips based 8051 hardware)
In this project we are going to tell you about how we can interface 7 segment display with 8051 microcontroller.
Step 1: Software Used:
As we are showing proteus simulation so FOR CODING AND SIMULATION YOU REQUIRED:
1 Keil uvision: Their are lots of product from keil. so you will be required c51 compiler. You can download that software from here
2 Proteus Software for simulation: This is the software to show simulation. You will get lot of information to download this software.
If you are doing it in hardware then you would require one software that is flash magic to upload the code in your hardware. Remember flash magic is developed by nxp. So you can not upload all 8051 family microcontroleer through this software. So Philips based controller only you can upload.
Step 2: Components Required:
Here in our demo video we are using proteus simulation but definetly if you are doing it in your hardware you will be required these components for this project:
8051 Development board: So if you have this board it will be better so that you can easily upload the code by yourself.
Seven Segment Display: There are two types of 7 segment display one is Common Anode and other is Common Cathode. In our Proteus simulation we are using Common Anode Display
USB to UART converter: This is 9Pin D type male Connecter For Rs232 O/p Jumper Wires
Step 3: Circuit Diagram
Step 4: Source Code
You can get the source code from our GitHub Link
Step 5: Working Principle and Video
You need to pass the correct hex code to generate numbers in 7 segment display. You can watch the video of this project. Working principle and code I’ve explained there
If you have any doubt regarding this project feel free to comment us below. And if you want to learn more about embedded system you can visit our youtube channel
Please visit and like our Facebook Page for frequent updates.
This channel just now we have started but daily you will get some videos regarding embedded system and IoT. Thanks & Regards,
Source: Interfacing 8051 Microcontroller With 7 Segment Display
- What software is required for coding and simulation?
Keil uVision with the C51 compiler for coding and Proteus for simulation. - Can I upload code to hardware, and what tool is used?
Yes, Flash Magic is used to upload code to Philips based 8051 microcontrollers. - Which type of 7 segment display is used in the Proteus simulation?
A Common Anode 7 segment display is used in the Proteus simulation. - What hardware components are recommended for this project?
An 8051 development board, a seven segment display, USB to UART converter, and jumper wires are recommended. - Where can I get the source code for this project?
The source code is available from the GitHub link provided in the article. - How do I generate numbers on the 7 segment display?
You must pass the correct hex codes to the display, as explained in the video. - Is there a demonstration of the project?
Yes, a working principle and demonstration video is provided at https://youtu.be/M_i5RkvzXIw. - Can Flash Magic upload code to all 8051 family microcontrollers?
No, Flash Magic supports uploading to Philips based 8051 microcontrollers only.
