Do you face such situations when you leave your reading lights, table fans or soldering irons without switching them off and later realize that they were on for too many hours which subsequently jumps off your electricity bills? Well, if you have such a problem of forgetting things which probably most of you would have […]
Energy Saving Switch With Presence Sensor Read More »
Meet Temper, a compact, low power temperature sensor based on ESP8266 and SHT30 with a large 13×7 pixel led display. It accesses WiFi periodically to display temperature and humidity data as well as battery percentage via the MQTT protocol. The device’s display uses three 74HC595 + 7 n-fets, TP4054 to handle battery charging through a USB and MCP1700T LDO to power the ESP. For WiFi setup, Temper
TEMPER: SLEEK TEMPERATURE SENSOR BUILT ON ESP8266 Read More »
Hello Builders! The title of this ‘ible is quite simple and so is this project made with the LinkIt One Board. It will detect the amount of light in your surrounding and if its low and motion is detected then turn on the led. This nightlight plugs directly into the wall with the help of
LinkIt One Motion NightLight Read More »
Kids just aren’t huge fans of brushing their teeth. Not only are they not huge fans, they also are pretty bad at it. Teaching a young kid to brush their teeth is really hard. I created a little contraption that not only times them to make sure they brush for an entire two minutes, but
Toothbrushing Instructor Read More »
Do you want to take revenge from your friend or your elder brother because he fooled you on a occasion. Are you searching for something by which you can scare anyone and have fun. If that is the case then you are at the right place. This instructable will tell you how to make a
Linkit One Motion Sensor Prank Read More »
Have you ever met to this problem that urgently you have to go somewhere and you are try to call your wife or children to tell them about the problem but unable to call them due to some network error. I am sure on some point in life you have met with this type of
Linkit One Audio Messenger Read More »
Vishay Intertechnology, Inc.today broadens its optoelectronics portfolio with new RGBC-IR sensors for applications such as automatic white balancing and color cast correction in digital cameras; automatic LCD backlight adjustment; and active monitoring of LED color output for IoT and smart lighting. The new VEML3328 (top-looking) and VEML3328SL (side-looking) sensors offer better linearity and higher sensitivity
VISHAY’S INTEGRATED RGBC-IR COLOR SENSORS WITH I²C INTERFACE IN LOW PROFILE PACKAGES Read More »
The RedRock™ RR121-1A53-311 is a magnetic sensor with a digital logic output from Coto. It features available operate sensitivity of 9G with an omnipolar magnetic field response all with a supply voltage of 3Vdd(typical), an average supply current drain of 1.44µA, as well as a high operating temperature from −40°C up to +125°C. The RedRock™ RR121 series
REDROCK™ TMR MAGNETIC SENSORS FROM COTO TECHNOLOGY Read More »
This instructable will guide you to use a flame sensor with the Mediatek Linkit ONE. A flame sensor is a device that can detect the presence of fire nearby. A buzzer connected to linkit one beeps when fire is detected by the sensor. So let’s get started…… ☺☺? Step 1: Parts Required The following parts
Linkit ONE: Flame Sensor Read More »
This instructable will guide you to glow an LED using a touch sensor which means that the LED will glow when you touch on the probe of the sensor. The project uses the Mediatek linkit one connected to a touch sensor and an LED. As soon a touch is detected, the output goes high which
Linkit ONE Touch LED Read More »
