This is a good project for beginners. It is easy to build.This running LED light uses seven bicolor led’s red and yellow, they light up in a pattern that can be made within the program code.The program code is written in assembler. ATMELs AVR STUDIO is used to write the program. The project uses the […]
Running LED bicolor Read More »
his project shows the temperature on a three digit 7-segment display, it measures the temperature from -9.5 to 99 degrees Celcius in 0.5 C steps, or from 0 to 210 degrees Fahrenheit in 1.0 degrees steps. Because of the LED display the temperature is also readable in the dark. This project is available pre-assembled and
This example is based on a LCD module with the Hitachi HD44780 LCD-controller.You can get these displays in various kinds, from 1 to 4 lines and from 8 to 40 characters per line. A display with 16 characters per line and 2 lines is used in this example. The display uses a power supply of 5V
Page 1 of 4 An RGB LED is a LED which has three LED’s integrated in one packaging. These LED’s have the colors Red, Green, and Blue. The RGB LED used here is a hyperflux LED with common cathode, which can draw 20mA current. Such a LED costs about 2€. With these three colours you can
RGB LED color mixer Read More »
With this circuit you can drive a unipolar stepper motor. It operates in full step mode. The AVR attiny2313 micro controller controls the pulses for the stepper motor. The pulses are amplified by the ULN2003 driver. The driver accepts 5V inputs, the output for the driver is up to 30V so you can connect an
Stepper motor driver Read More »
Schematic and build Below is the schematic of the LED VU meter. The circuit is builds with the ATMega328 board an two LED boards connected to it. You can also build it on a breadboard. For more detail: LED VU meter
This project uses a Dallas DS1621 temperature sensor which indicates the temparature of the device. The temperature sensor has an thermal alarm output, which becomes high when the temperature of the device exceeds a user defined value. When the temperature drops below a user defined value, the alarm output becomes low. In this way any
Temperature indicator Read More »
This running LED or LED chaser is a good project for beginners in the microcontroller technology. It is easy to build, and the assembler program code can be easily adapted. This running LED light has 15 red 3mm LED’s. The 15 outputs of ports B and D are used to drive the leds. The LED’s light up
Running LED's using ATTiny2313 Read More »
This small project let you make running leds. For this project you need a attiny2313 microcontroller and 8 leds and 8 resistors. The leds can be programmed so that they show differrent patterns. Hardware The leds are connected to PORTB of the microcontroller via the resistors that limit the current to 20mA. The project can
With this circuit you can control two unipolair stepper motors in full step mode via the RS232 serial port of your PC. A terminal program such as Hyperterminal can be used to control the stepper motors. The stepper motors can be driven one at a time. Features: Drives two unipolair stepper motors in full step
PC stepper motor driver Read More »
