Tomu family of USB devices has recently introduced a small form factor board that is not only a single MCU or an FPGA, but a complete System-on-chip that fits easily inside a USB port. The tiny compact board called Qomu, is a capable USB device that integrates an EOS S3 low-power MCU and an eFPGA with 100% open source tools. […]
MEET QOMU – A COMPLETE SOC THAT EASILY FITS INSIDE A USB PORT Read More »
Texas Instruments UCC27288 Half-Bridge Driver is a robust N-channel MOSFET driver with a maximum switch node (HS) voltage rating of 100V. It allows for two N-channel MOSFETs to be controlled in half-bridge or synchronous buck configuration based topologies. Its 3.5A peak sink current and 2.5A peak source current, along with low pull-up and pull-down resistance, allows the UCC27288
TEXAS INSTRUMENTS UCC27288 HALF-BRIDGE DRIVER Read More »
Alliance Memory 2Gb, 4Gb, and 8Gb LPDDR4 SDRAMs Offer Low Power Consumption to Increase Battery Life in Mobile Electronics; Devices Combine Low-Voltage Operation of 1.1V With Fast Clock Speeds of 1.6GHz for increased Efficiency and Performance The 2Gb AS4C128M16MD4-062BAN, 4Gb AS4C256M16MD4-062BAN and AS4C128M32MD4-062BAN, and 8Gb AS4C256M32MD4-062BAN provide lower power consumption and faster speeds than the previous-generation LPDDR3 SDRAMs. The devices are available in
2GB, 4GB, AND 8GB LPDDR4 SDRAMS WITH LOW POWER USAGE Read More »
There are a lot of different LCD display interfaces depending on the requirements of resolutions, speed, cost, stability etc. The following outlines the common ones on the market: Parallel Vs Serial Interface Parallel interface could transmit many data bits at the same time depending on the data bits width. PROs: Simple CONs: Need RAM, Speed is limited.
AN INTRODUCTION: LCD COMMON INTERFACES Read More »
A team of researchers made up from the University of California San Diego and California-based company ZPower have developed a flexible, rechargeable silver oxide-zinc battery with a 5 to 10 times greater energy density than standard batteries. A good characteristic of the battery is that it is easier to manufacture because most flexible batteries need to be manufactured in sterile conditions, under vacuum,
Axiomtek – a world-renowned leader relentlessly devoted in the research, development and manufacture of series of innovative and reliable industrial computer products of high efficiency – is pleased to announce the AIE100-903-FL-NX, its ultra-compact and state-of-the-art edge AI system. The high-performance AIE100-903-FL-NX is powered by the NVIDIA® Jetson Xavier™ NX module which has a powerful 6-core NVIDIA® Carmel ARM® v8.2 64-bit
Texas Instruments’ driver features integrated current sense, 1/256 microstepping, STEP/DIR interface, and smart tune technology Texas Instruments’ DRV8428 is a stepper motor driver for industrial and consumer applications. The device is fully integrated with two N-channel power MOSFET H-bridge drivers, a microstepping indexer, and integrated current sensing. The DRV8428 can drive up to 1 A full-scale output
DRV8428 35 V, 1 A BIPOLAR STEPPER MOTOR DRIVER Read More »
The project presented here provides an isolated interface between the RS-232 cable network and the connected UART systems to protect against voltage spikes and ground loops within the noisy environment and improve system reliability. The project achieves a robust data communication link in harsh industrial environment. ADM3251E chip from Analog Devices is the heart of the project, this chip is a high speed,
ISOLATED, SINGLE-CHANNEL RS232 TRANSCEIVER (ISOLATED RS232 TO UART) Read More »
Reclaimer Labs has launched an STM32WB Feather development board that is based on STMicro’s first wireless STM32 MCU which was announced sometime around last year. The STM32WB Feather board like other development boards in the STM32 family of wireless MCUs is built around the STM32WB55CG SoC which includes an 64MHz Arm Cortex‐M4 running as the main processor along with a 32MHz Cortex‐M0+
STM32WB FEATHER DEVELOPMENT BOARD WITH STM32WB55 BLUETOOTH 5.0 SOC SELLS FOR $45 Read More »
GNSS location with standards like GPS is a key feature of smartphones and other devices. They enable you navigate around, and share your location with friends, family, and business contacts. However, sometimes we find it difficult to get an accurate location because of a number of factors like tall buildings in urban area bouncing the satellite network, etc.
3D MAPPING IMPROVES URBAN GPS ACCURACY FOR YOUR APP Read More »
