OKDO E1 DEVELOPMENT BOARD

OKdo, part of the Electrocomponents Group, introduced its first own-branded single board computer (SBC), the E1.

The OKdo E1 is an ultra-low-cost Development Board based on the NXP LPC55S69JBD100 dual-core Arm Cortex® M33 microcontroller. The E1 board is perfect for Industrial IoT, building control and automation, consumer electronics, general embedded and secure applications.

Key Features

  • Processor with Arm TrustZone, Floating Point Unit (FPU) and Memory Protection Unit (MPU)
  • CASPER Crypto co-processor to enable hardware acceleration for certain asymmetric cryptographic algorithms
  • PowerQuad Hardware Accelerator for fixed and floating point DSP functions
  • SRAM Physical Unclonable Function (PUF) for key generation, storage and reconstruction
  • PRINCE module for real-time encryption and decryption of flash data
  • AES-256 and SHA2 engines
  • Up to Nine Flexcomm interfaces. Each Flexcomm interface can be selected by software to be a USART, SPI, I2C, and I2S interface
  • USB 2.0 High-Speed Host/Device controller with on-chip PHY
  • USB 2.0 Full-Speed Host/Device controller with on-chip PHY
  • Up to 64 GPIOs
  • Secure digital input/output (SD/MMC and SDIO) card interface

Specifications:

  • LPC55S69JBD100 640kbyte flash microcontroller
  • In-built CMSIS-DAP v1.0.7 debugger based on LPC11U35
  • Internal PLL support up to 100MHz operation, 16MHz can be mounted for full 150MHz operation.
  • SRAM 320kB
  • 32kHz crystal for real-time clock
  • 4 user switches
  • 3-colour LED
  • User USB connector
  • 2-off 16-way expansion connectors
  • UART over USB virtual COM port

Read more: OKDO E1 DEVELOPMENT BOARD


About The Author

Muhammad Bilal

I am a highly skilled and motivated individual with a Master's degree in Computer Science. I have extensive experience in technical writing and a deep understanding of SEO practices.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top