EGYDuino is a DIY Arduino clone made on a single sided PCB board. It’s simple and cheap to build using home PCB fabrication methods and it’s 100% compatible with Arduino. Description ATmega8 takes care of the USB to serial communication and should be burned with AVR-CDC232 firmware. AVR-CDC creates a virtual COM port on the […]
EGYDuino – Arduino compatible board Read More »
This project is a development board for Atmel ATmega64 microcontroller and can be used to easily develop custom AVR firmware or as an introduction board to microprocessors and programming. A development board is better to be used instead of a breadboard setup as it facilitates the connection of the different components using PCB headers. The
ATmega64 Development Board Read More »
It’s been a while since I posted a new article, a delay at least partly due to me herniating a disc in my neck which left me completely unable to look downwards for any length of time and as you’ll know all too well you can’t work on circuit boards without peering down at them.
A development board for the STM32F042 Read More »
The ESP8266 chip, and the boards based around it, have been the new hot new thing this past year. Overnight it became — almost by stealth — one of the leading platforms for the Internet of Things. This runaway success quickly gathered a community, and it’s possible Espressif Systems may repeat that next year with their new ESP32 chip. About a
Meet ESP32, New Big Brother to IoT Board ESP8266 Read More »
In this instructable I’m going to show you how to make your own PIC18 development board that features both Ethernet and Full Speed USB 2.0 at a low cost. Features: The development board is based on a PIC18LF4553 microcontroller. The microcontroller features a Full Speed USB 2.0 (12Mbit/s) interface without the need for any external
PIC18 Development Board with Ethernet and USB Read More »
The PIC 40 / 28 PIN (DIP) Development / Evaluations board demonstrates the capabilities of Microchips 8-bit microcontrollers, specifically, 28- and 40-pin PIC16FXXX, PIC16F1XXX, and PIC18 devices. It can be used as a standalone demonstration board with a programmed part. With this board you can develop and prototype with all Microchip’s 40 & 28 PIN
40 & 28 PIN PIC Development Board Read More »
This is a peripheral board with 4 relais, rated at 5A/250V each. The board has a ML10 output connector for connection with the AT2313 Project board. It has also 4 LED’s for indication which relais is switched on. Hardware The circuit is simple, it consists of no more then an ML10 connector, a ULN2803A, which
Relais Driver Board Read More »
This instructable shows, how to do your own development board for Atmega16 or Atmega32 processors.The Internet is full of home made development boards, but I think that, there is room left for another one. This board have been very useful on my projects and I actually designed and made it to serve one of my
Atmega16/32 Development Board With LCD Read More »
Introduction For our final project in ECE 4760, we designed and implemented a Reversi board consisting of hardware, a microcontroller, and a touch screen. Sixty-four bicolor (red and green) LEDs were implemented as the black and white pieces of the game. Players could simply light up a LED (place a piece) by touching the touch
Digital Reversi board using Atmega644 Read More »
1 Introduction Our final project is the CUSat Diagnostic Board (CUDB). This board will be used for monitoring CUSat system health as well as performing various functions allowing for easy integration and debugging of CUSat components. 1.1 CUSat CUSat is the Cornell satellite team’s entry into the Nanosat-4 competition sponsored by the Air Force Research
CUsat diagnostic board using Atmel mega32 Read More »
