lcd interfacing

ATmega128 connected to LCD on breadboard

ATmega128 LCD Driver using ATmega128 with Proteus Simulation

AVR ATmega Projects, Circuits, How It Works, LED Projects, Microcontroller / Ibrar Ayyub

Introduction This microcontroller project demonstrates how to directly drive a 2-digit 7-segment LCD using the powerful ATmega128 microcontroller without any dedicated LCD driver IC. Based on the well-known AVR241 application note, this project shows how general I/O pins can be used to control LCD segments efficiently. Using Proteus simulation, this setup helps visualize real-time LCD […]

ATmega128 LCD Driver using ATmega128 with Proteus Simulation Read More »

Thermometer using DS1621 and Nokia 3310 LCD interfaced with ATmega8

AVR ATmega Projects, Interfacing(USB - RS232 - I2c -ISP) Projects, Temperature Measurement Projects / Ibrar Ayyub

I am presenting one application with the Nokia 3310 LCD: Designing a thermometer using DS1621 temperature sensor IC. DS1621 is 8-pin sensor from Maxim, with temp range of -55 to +125 degree C, which can be interfaced with microcontroller over two-wire serial i2c bus. It has operating voltage range from 2.7 to 5.5v. I’m operating

Thermometer using DS1621 and Nokia 3310 LCD interfaced with ATmega8 Read More »

NOKIA 3310 LCD interfacing with ATmega8

AVR ATmega Projects, Interfacing(USB - RS232 - I2c -ISP) Projects, LCD Projects / Ibrar Ayyub

Using graphic LCD in a project gives it really a good look and flexibility of displaying different characters and shapes. But, the graphic LCDs are quite costly. The NOKIA 3310 LCD provides a really low-cost solution to add a small graphic display into your project and also good for learning purpose. The LCD is SPI

NOKIA 3310 LCD interfacing with ATmega8 Read More »

Scroll to Top