interfacing

Digital Telemetry using ATMega8 microcontroller

The ATmega8 microcontroller-based Low-Cost Telemetry Device (LTD) is an efficient telemetry keyer. The LTD measures the voltage levels of up to four analog channels via its on-chip 10-bit ADC, converts the measurements to numbers, and then sends the data in Morse code to an external transmitter and to an attached RS-232 terminal. It can be […]

Digital Telemetry using ATMega8 microcontroller Read More »

LC Resonant Frequency Meter using AVR microcontroller

A well known L/C measurement circuit is pressed into service to make a bare bones measurement circuit. Download the AVRStudio assembly source: lgm031227I.asm Download the AVRStudio hex file: lgm031227.hex Left-to-right: The 5 volt regulator, the LM393 oscillator (a 0.047 uf capacitor is mounted on the LC circuit connector), the AT90S2313, and the serial connector to

LC Resonant Frequency Meter using AVR microcontroller Read More »

Temperature Sensor Thermometer using AT89C51 and DS1621 microcontroller

Temperature Sensor Thermometer using AT89C51 and DS1621 microcontroller

DS1621 temperature sensor circuit digital thermometer to tell if using. Operation of the circuit is simple, as are as follows: temperature sensor from the numeric value being sent to the microcontroller and the microcontroller using the I2C serial communication protocol, this value will more basıyor.Biraz If the LCD tomicrocontroller interprets the sensor in the 16-bit LCD to the data transfers.

Temperature Sensor Thermometer using AT89C51 and DS1621 microcontroller Read More »

About Atmel and Combination Lock Application using AT90S2313 microcontroller

Microcontroller Microcontroller ‘s (MCU) is a kind of CPU (CPU) can be seen as. MIB MCUs from slower and less capable of addressing memory, but they are designed for the implementation of real-time control problems both cheaper and easier to use. The major difference between CPU and MCU are required to use external hardware. MCU, almost every time,

About Atmel and Combination Lock Application using AT90S2313 microcontroller Read More »

Led Animation Circuit with PC Connectivity using AT90S2313 microcontroller

Animator is a device, rather 5 × 16 matrix LED , which are used to display simple animation. Initially, the device serves to something completely different and it was controlled directly from the parallel port for the program is written in Pascal. The idea has proved to be a bit pointless because the program does not provide an even

Led Animation Circuit with PC Connectivity using AT90S2313 microcontroller Read More »

Serial interface with 2X16 LCD display using ATMega8515 microcontroller

The 10k potentiometer, just above the ISP connector near the lower middle of the board, is used to adjust the display contrast according to your vertical viewing angle. DOWNLOADS ATTINY2313/AT90S2313 AVRStudio assembler source. LDCbutons040904Ca.htm ATTINY2313/AT90S2313 AVRStudio assembler source. UPDATED FOR COMPATIBILITY WITH NEWER VERSIONS OF THE ASSEMBLER. LDCbutons040904C_updated_a.htm Truly LCD driver include file.  2x16lcdinc.htm tlcd309Ba.htm

Serial interface with 2X16 LCD display using ATMega8515 microcontroller Read More »

G1216B1N000 dot graphics display using AT90S2313 microcontroller

Download Assembler source code I was looking for an LCD display that I could use to display waveforms on the workbench. The selection criteria for the display module itself was straight forward: 1. Dot graphic with sufficient resolution to display a simple waveform, 2. Available for fast delivery, 3. Have sufficient documentation available online to

G1216B1N000 dot graphics display using AT90S2313 microcontroller Read More »

Scroll to Top