1 Starting Forth Forth[3] is a flexible, stack-based programming language that is ideal for embedded use. It has an amazing power to weight ratio; it can do a lot with limited resources. For... Read more
This project was done in order to experiment with the Automotakit breadboard board which is based on the ATMEGA256A3U chip. The use of a DAC, ADC , low pass filter, PWM, basic I/O, current c... Read more
I have been working on input and output devices communication for weeks. For those weeks, I spent so many times on the ESP32 debugging and got nothing solved, which makes me be so despair ab... Read more
1. Programming Board Blinking Code using Arduino environment CODE: I started with code code from Jaclyn Berry's page : const int buttonPin = 7; const int ledPin = 2; int buttonState = 0; voi... Read more
Introduction This page attempts to describe a procedure for installing a complete GCC-based toolchain on a modern Windows system. I’ve developed these instructions on my Windows 10 mac... Read more
Code explanation for MASTER Controller: Step 1: Initialization of master. Initialization of MASTER means to set the TWI clock frequency (SCL). It is done by setting bit rate in TWBR and pre... Read more
Step 1: Components and Where to Start I’ve started from the Arduino official site: https://www.arduino.cc/en/Main/Standalone where I’ve taken this picture, and where there is the... Read more
Step 1: The Beginning Last week I decided to make a classic Arduino clone with an ATMEGA328P-PU. I seemed to be so easy and quick but a very bad surprise for me : I odered the cheaper ATMEGA... Read more
Introduction The following diagram shows the system schematic. It contains the several major blocks: ATmega 323 is the CPU of the system. 5 VDC power supplier: an adaptor first transforms 11... Read more
Board Design For part of my final project I want to make my own USB audio recording device. So I’ll try to develop all the necessary electronics this week. I have the analog circuitry I need... Read more